High Def Forum
Thank you for visiting. This is our website archive. Please visit our main website by clicking the logo above.

Philips 55PW9363 55" HELP!

07-17-2011, 06:14 PM
Hey all,

I just picked up one of these TVs. It was taken part when i got it. I was wondering if i could get some pictures of the back circuit boards so i can put it back together.


07-19-2011, 08:24 PM
What all is taken apart?

It would be very difficult to put that back together by pictures. Many plugs will go into different connectors.

Good luck,

PS. You could look for an interconnect diagram.

07-20-2011, 08:31 PM
There are two large circuit boards in the back of the tv on the bottom. There are some connectors that are unplugged and have no label on them. Most of the connectors have labels but there's some I can't figure out.

07-22-2011, 05:54 PM
Yes there are two main boards. LSM (deflection/power supply) on the right and SSM (Signal and control) on the left.

Is this what you are seeing?


07-23-2011, 12:46 PM
Yes, those two boards. I can't figure out where some of the connectors plug into those boards.

07-23-2011, 12:48 PM
I tried posting some picture but it said I had to have 5 post or more.

07-23-2011, 12:49 PM
So disregard this post.

07-23-2011, 12:50 PM
Okay here are some pictures.

Here are multicolored connectors. Two of them have been marked with Red and Blue marker but it's not indicated on the board where they go.

Red Wire bundled with the multicolored wires

Second Red Wire.

Slots for multicolored connectors.

07-23-2011, 01:31 PM
A service manual will most likely help you, although I'm not sure where you might find that. Google will most likely yield some sort of result. As for the connectors, sometimes the length of the wire might help, as in one may connect but the other won't or barely will because of the length of the wire.

As for the red connector, that is most likely a grounding wire. It will attach to the board and then to the chassis nearby.


07-23-2011, 01:35 PM
Those are the Deflection Yoke connections. You will see the 3 plugs for them, they are all the same. I usually connect them the way the CRT's are mounted Left (red), Middle (green), Right (Blue).

Not sure of where the bladed connector should go, it is probably a DAG ground that is usually connected from the CRT to the shield around them.

Hope that helps,

07-27-2011, 12:21 PM
Alright I have the "yoke" connectors all in thanks to "TV-Tech". Now i just need to know where these RED and BLACK wires go. I took some more pictures of some of the spots on the boards those wires could go.

Here is a black wire I found while taking pictures

Heres three male connectors i found on the bottom, back left corner.

Heres the corner I'm talking about

Theres another male connector over by the power cord on the bottom right.

Here is another male connector. I circled in red on the left. The connector by the power cord is circle on the right

Also, there is male ribbon connector that i found. I can't seem to find another ribbon cable for that connector. Weird.

I really appreciate this.

08-02-2011, 01:33 PM
Anyone have an idea where those wires go? I wanna try and get this TV up and working the week.