High Def Forum
Thank you for visiting. This is our website archive. Please visit our main website by clicking the logo above.

aligning high def. for bell

harv
12-31-2010, 07:26 AM
High Folks new here, so please have some patience, anyhow just wondering when hooking up a high def. Bell receiver would I need a switch or can I get a signal just running direct, what I'm looking at doing is running a duel lnb bracket with 2 lines running standard from one lnb and 2 lines running high def, can I do this without a switch, all 4 lines will run direct to the receivers, also would I line up 91 first , then 82 should automatically be there with the duel bracket? Any help would be appreciated. Thanks

Meld
01-01-2011, 11:13 AM
I would suggest using an SW44 it is the easiest way to get 91 & 82 feeds to upto 4 Receivers.

As for Aiming, well, if you are using a standard 20" (51cm) Bell Dish, you should set the Skew for your location first, before anything. Then run a direct line from the 91 LNBF to a Receiver, peak the signal, then add the 2nd LNBF and the SW44, run a Check Switch (MENU 6, 1, 1) and that should be it.

Power Inserter MUST be on Output Port #1.