Registered: August 2005 Location: Formerly: Brooklyn, N.Y. Currently: Ridge, Long Island, N.Y. Heavenly E. End of America Posts: 5497
Wed June 27, 2007 12:38pm
Rating: 9.00
Nice setup........ I was wondering if fireplace is for show or do you use it. If you use it I would put a thermometer on the mantle to sample the heat and a piece of white paper to check for soot which could attach itself to the screen, remember electrical components act as a magnet for dust and soot (screen biggest enemy) But setup look really nice enjoy
------------------------------ RIZZ'S HI-DEF "MAN TOYS" http://www.highdefforum.com/gallery/.../1080P_001.JPG SONY LCD KDL-46 XBR4 1080P SONY LCD KDL-32 SL130 768P SONY Blu-Ray BDP-S550 DENON 3805S AVR 7.1 - 120w/ch x7
Mirage Omnistat V2-FS Front towers
Mirage Omnistat V2-CC Center channel
Mirage Omnistat V2 Satellites
Mirage Omni S-8 Subwoofer
Scientific Atlantic Explorer 8300 HD-DVR
Harmony 880 Remote
Monster HTS 1000 MKII PowerCenter
Monster THX Cables
Canon XTi 10MP
dead7 How can anyone watch standard def?
Registered: February 2007 Posts: 16
Fri June 29, 2007 12:59pm
Thanks for the comments. Yep we use it! Before the system was designed (or even before the walls were framed) we were sure to use a blown & rear vented gas fireplace. The ambient temperature under that big mantel never reaches over 80. Above the mantel basically stays at room temperature with a minor fluctuation of a few degrees. The component & speaker lines are all tucked through the studs routed back and down away from any obstructions or heat vents. The ducting behind the fireplace is also reverse insulated to keep the heat going outside and not sitting behind the wall.
The lines then take a generous 40 foot path through the basement ceiling all the way to the component closet located near the front of the house, which is also vented for the electronics.
Powered by: PhotoPost PHP vB3 Enhanced Copyright 2005 All Enthusiast, Inc.
High Def Forum - Your High Definition Community & High Definition Resource
