Originally Posted by Bigloww

I can't remember if they did or not, but I think so.. If not, ust run down to your local hardware/Menards store and grab a few. They where Hex head lag screws about 3'' long and about as thick as the pre-drilled holes on the mount brcket. Just grabbed a lag/hex driver for your cordless drill and a level and had that ting up in 5 minutes.

The only screws it did not come with (or were not usable) that I remember were the ones that connected the VESA plate to the TV (not sure if the TV came with them or not). But the screws that secured the stand to the TV were not the same as the screw for the VESA mount, so off the ACE hardware I went.. Your TV may be different and include them or work with the ones they ship.. If not they are not hard to match up..


The Lag screws look like these pic's...

http://www.jamestowndistributors.com...word=lag_screw

You just pick the left 3 or right 3 set of holes on the mount to use as it is too wide to use all 6 for 1 stud.. But 1 side is more than enough to support the weight with a good stud and those lag screws. Even your 66 pound beast..

I can try and post a couple pics if you like..